IPv6 design, deployment, standards, and best practices.
ddoberloh
New Member
Posts:
1
Joined:
Tue May 15, 2012 2:45 pm

Ipv6 source address configuration

Tue May 15, 2012 2:50 pm

I have a quick question about forcing windows to use the ip of one of its adapters for source addresses when sending messages. I have two ipv6 adapters in my computer, one is a virtual tunnel and the other is my physical wireless card. When i ping a remote server, I want the source address to be the one from my wireless adapter, not the virtual tunnel adapter. I am aware of the -S command when pinging, but i want to configure the algorithm windows uses to choose the one I want. I have been messing around in netsh with prefixpolicies. Am I even close???

Thanks

'
Return to IPv6

Who is online

Users browsing this forum: No registered users and 4 guests