Dynamips/GNS3, .net files, and Cisco networking labs.
New Member
Wed Apr 08, 2015 2:00 am

Cannot ping ASA in GNS3 1.2.x & 1.3

Wed Apr 08, 2015 2:16 am

hey there, my lab scenario
cloud ( bridged to my loopback windows adapter )
the cloud is connected via switch to a router and an ASA.
cloud IP :
router :
i can ping from cloud to router and vice versa everything is working fine but cannot ping the ASA nor the ASA can ping my loopback
ASA gigabit interface 0 config
ip address
no shut
nameif inside
management-access inside

Note: the same config for the ASA in GNS3 0.8.x used to work perfectly but the problem started in GNS3 1.2.x & 1.3
i even added inspection for icmp
not even telnet is working even after i enable it on the interface.
i installed GNS3 on windows 8.1 x64 and win7 x64 but the problem is the same.
Any help or ideas is appreciated.

Return to Dynamips/GNS3 and Labs

Who is online

Users browsing this forum: No registered users and 10 guests