RIP, EIGRP, OSPF, IS-IS, BGP, MPLS, VTP, STP.
alienkidmj12
New Member
Posts:
33
Joined:
Mon Apr 22, 2013 1:32 pm
Certs:
mcp

help setting up vpn on cisco

Sat Oct 20, 2018 3:52 am

Hi,

Im looking for some assistance with setting up a vpn on my cisco 2851 router.

Cisco 2851 (revision 1.0) with 245760K/16384K bytes of memory.
Processor board ID FCZ104774FT
2 Gigabit Ethernet interfaces
1 Serial(sync/async) interface
1 ATM interface
1 terminal line
2 Virtual Private Network (VPN) Modules
1 802.11 Radio
1 Cellular interface
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
3923640K bytes of ATA CompactFlash (Read/Write)


The VPN service im trying to setup is express vpn,

they have supplied my username, password, shared key,

i believe they use aes as a cipher, and so i have attempted to configure the connection, im a bit lost as to why my crypto are incomplete, and also how i configure my login for username and password. can someone assist,

my config below so far,


crypto isakmp key 12345678 hostname uk-east-london-ubuntu-l2tp.expressprovider.com
crypto isakmp key 12345678 hostname uk-docklands-ubuntu-l2tp.expressprovider.com
crypto isakmp key 12345678 hostname uk1-ubuntu-l2tp.expressprovider.com
!
!
crypto ipsec transform-set expressvpn-berkshire esp-aes esp-md5-hmac
crypto ipsec transform-set expressvpn-eastlondon esp-aes esp-md5-hmac
crypto ipsec transform-set expressvpn-docklands esp-aes esp-md5-hmac
!
crypto map expressvpn-berkshire 10 ipsec-isakmp
! Incomplete
set peer 78.129.189.237
set transform-set expressvpn-berkshire
match address 100
!
crypto map expressvpn-docklands 10 ipsec-isakmp
! Incomplete
set peer 185.217.117.250
set transform-set expressvpn-docklands
match address 100
!
crypto map expressvpn-eastlondon 10 ipsec-isakmp
! Incomplete
set peer 85.203.46.116
set transform-set expressvpn-eastlondon
match address 100

alienkidmj12
New Member
Posts:
33
Joined:
Mon Apr 22, 2013 1:32 pm
Certs:
mcp

Re: help setting up vpn on cisco

Sat Oct 20, 2018 4:15 am

i seem to have solved the Incomplete issue, just added an access list, just need to understand how to authenticate with credentials now.

'

Return to Cisco Routing and Switching

Who is online

Users browsing this forum: Exabot [Bot] and 122 guests